Craftsman 16 in variable speed scroll saw manual

Table Of Contents. Quick Links Download this manual. Table of Contents. Operator's Manual. Sears, Roebuck and Co. Visit our Craftsman website: www. Previous Page. Next Page. Related Manuals for Craftsman Saw Craftsman Summary of Contents for Craftsman If this tool is used for commercial or rental purposes, this warranty will apply for only ninety days from the date of purchase. Safety Goggles are available at Sears. Page 5 lag fuse or a 14 wire with a 15 A time-lag fuse. To prevent personal injury, always turn the saw CAUTION: In order to avoid uncontrollable lifting of the OFF and disconnect the plug from source before workpiece, the teeth of the blade should always point downward.

The blade guard foot is not To avoid injury from accidental starting, always turn designed to hold down the workpiece, but rather a guard the switch OFF and unplug the scroll saw before to help prevent the workpiece from lifting up excessively.

When feeding the workpiece into the blade do not The variable speed control allows greater versatility to force the leading edge of the workpiece into the blade cut a variety of materials such as wood, plastics, non- because the blade will deflect, reducing the accuracy ferrous metals, etc. When the cut is complete, move the trailing edge of the workpiece beyond the blade guard foot. Related Manuals for Craftsman Contractor series 20" variable speed scroll saw 26 pages.

Saw Craftsman Summary of Contents for Craftsman Do not store from rain. Keep work area wel! Don't force tool or like iron or steel.

When cutting attachment to do a job it was not nonferrous metals brass, copper designed to do. Page 5: Whenever Saw Is Running Plan the way you will hold the work- positions where a sudden slip could piece from start to finish. Page 7: Volt, 60 Hz. Tool Volt, 60 Hz. Tool If the grounding instructions are not com- pletely understood, or if you are in doubt Information as to whether the tool is properly NOTE: The plug supplied on your tool grounded check with a qualified electri- may not fit into the outlet you are plan- cian or service personnel.

Cord Length ,. The use of any extension cord will cause V some loss of power. To keepthis to a minimum and to prevent overheating Ft. NOTE: A rubber band looped aroundthe back of the blade holder will automati- cally open the jaws when the knobs are loosened which will make changing Page 16 Alignment Adjustments continued.. Loosen tension on blade by turning ten- sion knob counterclockwise about three full turns. NOTE: A rubber band looped around the back of the Made holder wiIl automati- cally open the jaws when the knobs are loosened which will make changing blades easier.

No adjust- ment is necessary to the blower. Inspect your saw. To avoid injury areas and benches invite accidents. Page 23 P!